VampFangs.com - Custom Fangs and Accessories

HOW THEY WORK   A) MIX: Pour powder from one capsule into the deep side of the carry case, by gently twisting the capsule ends apart. Remove bottle lid, snap off tip and dispense 7 drops ( for "Shredders" use 14 drops )onto the powder. Pick up the case in your hand and tilt slightly. Stir with the stick provided for 10-15 seconds until the mixture is uniform and just pasty while keeping the material in a glob at the lower edge of the tilted case as not to waste any.   B) FIT: Scoop the glob of material into one fang, applying it onto the front and back as evenly as possible rather than just filling up he cavity in the fang. Gently push the fang all the way up onto your tooth, attempting to locate the best position in one motion as discussed. Try not to wiggle, adjust or reposition the fang after you push it all the way up. Leave it on for 5 minutes so it can harden, but do not remove it yet, and don't work on the next fang until 5 minutes has passed so that you  don't accidentally loosen it before it sets up. With the first fang in place, position the next fang in a mirror. Orient this fang relative to the first so that it has a similar angle and looks natural. After you practiced putting it on accurately, follow steps A and B again.   C) REMOVE: The Interliner continues to harden even after you've finished fitting your fangs. To prevent them from getting stuck on your teeth, remove your fangs to "break the seal" right after you complete the customizing process on both fangs, then you can then put them back on. Gently push you lower teeth forward against the backside of the fang tips until you hear a slight click (see illus.C). Then wiggle and pull gently with your fingers until they loosen up. It may take a minute the first time you remove them. Your fangs will now clip on and off easily, yet fit snug. TIP: If fangs are well positioned but you want them to fit tighter, customize again over the existing liner with a single capsule, but remember to remove them after they're done. Use only one capsule to customize over the existing interliner for both fangs.